ASI Padded Folding Shower Seat


$435.00
Always Free Shipping
Model: 108-8205x-1
Shipping Weight: 45lbs
Manufactured by: ASI


HygienicItem.png

ASI Folding Shower Seat

 

The ASI Folding Shower Seat is a closed cell sponge cushion covered with off-white Naugahyde® sealed cover mounted on 1⁄2" thick, marine-grade plywood. The ASI Folding Shower Seat is available in either a Left side L or a Right side L shaped seat. Spring loaded so the seat will stay up and out of the way when not needed and easily folds down for convenient use. The padded seat provides additional comfort for those with sensitive skin or is prone to skin breakdown. 

SPECIFICATION

This seat is an “L- shaped” Fold-up Padded Shower/Bath Seat The ASI Folding Shower Seat is fabricated using 18-8 stainless steel type 304; seat frame and support legs are 1" diameter and 1-1/4" square x 18 gauge tubing with 3/16" thick mounting flanges and 16 gauge guide bracket/arm support. All exposed surfaces shall have No 4 satin finish. Structural assembly shall be of welded construction. All exposed edges and corners are rounded and edges are smooth.

 

INSTALLATION

This unit is surface mounted. Installer/contractor must provide concealed anchor plate or blocking as specified in construction documents or as required by local building codes prior to wall finishing. Fasten unit flanges and guide bracket to concealed anchor or blocking plate with appropriate hardware. See “STRENGTH” section below. Note that concealed mounting plates or anchors and hardware are not supplied with this product and must be specified separately.  Ensure that mounting configuration complies with local building codes. 

STRENGTH

ASI Shower Seats are designed to meet and exceed ADAAG requirements as published in ICC/ANSI A117.1-2003 section 610 and CFR 28 Part 36, Federal Register Vol. 56, No 144, July 26, 1991, section 4.21.3 and section 4.26.3, that fabricated product shall be of adequate strength to support a load of 250 pounds and unit shall conform to size and edge clearances as diagrammed. Mounting to the wall is a critical part of the system to meet this requirement. To withstand the shear, tension or pullout, and torsion loads generated by the maximum loading, the fastener system must be adequately sized. Unit is load rated to support a weight of 500 lbs at front edge when properly installed and has been tested to successfully hold a weight in excess of 1000 lbs.

8205x dim.jpg

NOTE: Left or Right is determined from the sitting position, example if when sitting on the seat the long side is on your right you would order the Right Side. 

Product Literature
Technical Data Sheet


Please Choose:




Add to Cart: