Cart empty
Call: (877) 748-3935

ASI Padded Folding Shower Seat

Salesprice with discount
Price: $435.00
Price / kg:
Model: 108-8205x-1
Shipping Weight: 45lbs
Manufactured by: ASI
  • Model
    Some options may be required. Required options that are not selected will be highlighted after clicking add to cart.
  • ASI Folding Shower Seat

    The ASI Folding Shower Seat is a closed cell sponge cushion covered with off-white Naugahyde® sealed cover mounted on 1⁄2" thick, marine-grade plywood. The ASI Folding Shower Seat is available in either a Left side L or a Right side L shaped seat. Spring loaded so the seat will stay up and out of the way when not needed and easily folds down for convenient use. The padded seat provides additional comfort for those with sensitive skin or is prone to skin breakdown. 

    This seat is an “L- shaped” Fold-up Padded Shower/Bath Seat The ASI Folding Shower Seat isfabricated using 18-8 stainless steel type 304; seat frame and support legs are 1" diameter and 1-1/4" square x 18 gauge tubing with 3/16" thick mounting flanges and 16 gauge guide bracket/arm support. All exposed surfaces shall have No 4 satin finish. Structural assembly shall be of welded construction. All exposed edges and corners are rounded and edges are smooth.

    This unit is surface mounted. Installer/contractor must provide concealed anchor plate or blocking as specified in construction documents or as required by local building codes prior to wall finishing. Fasten unit flanges and guide bracket to concealed anchor or blocking plate with appropriate hardware. See “STRENGTH” section below. Note that concealed mounting plates or anchors and hardware are not supplied with this product and must be specified separately.  Ensure that mounting configuration complies with local building codes. 

    ASI Shower Seats are designed to meet and exceed ADAAG requirements as published in ICC/ANSIA117.1-2003 section 610 and CFR 28 Part 36, Federal Register Vol. 56, No 144, July 26, 1991, section 4.21.3 and section 4.26.3, that fabricated product shall be of adequate strength to support a load of 250 pounds and unit shall conform to size and edge clearances as diagrammed. Mounting to the wall is a critical part of the system to meet this requirement. To withstand the shear, tension or pullout, and torsion loads generated by the maximum loading, the fastener system must be adequately sized. Unit is load rated to support a weight of 500 lbs at front edge when properly installed and has been tested to successfully hold a weight in excess of 1000 lbs.

    8205x dim.jpg

    NOTE: Left or Right is determined from the sitting position, example if when sitting on the seat the long side is on your right you would order the Right Side. 

  • Reviews

    There are yet no reviews for this product.
  • Product Literature:
    Technical Data Sheet

Live Well Medical Supplies will provide the best medical products at the fairest prices and generally the lowest prices. Provide a site that you find easy to use and can provide value. We will donate at least ten percent of our profits back to organizations that assist person with SCIs and other disabling illnesses that do not have the means to get equipment and therapy that would help improve their quality of life.